SaunaLife TITAN Takes Propane Heat Into Portable Saunas
By Arlene Scott
Senior Wellness Correspondent & Hospitality Consultant
- Published
- Reading time
- 2 min
SaunaNews is published by SaunaShare, Inc., which also runs SaunaShare.com and SaunaMarketplace.com, where we sell many of the products we write about. Assume that experience shapes what we cover and what we don't. Who owns SaunaNews · The ownership announcement
The 33-pound TITAN SL1 runs without electricity or a permanent gas line. SaunaLife approves it for its SaunaTrekker tents and properly built sauna rooms.
In this story2 sections
SaunaLife’s TITAN SL1 gives portable saunas a propane-fired heater that runs without an electrical hookup, a permanent gas line or a chimney. The stainless-steel unit weighs 33 pounds before stones and works with the company’s SaunaTrekker and SaunaTrekker XL tents.
The manufacturer’s product page lists a 44-pound stone basket and a footprint of about 13.1 inches wide by 19.6 inches deep, with a height of 27 inches. SaunaLife rates it for uninsulated saunas of 140–350 cubic feet and insulated saunas of 140–425 cubic feet.
Propane replaces the electrical connection
SaunaLife says a standard 20-pound propane cylinder can provide approximately 18–30 hours of operation, depending on the heat setting. It also claims sauna-ready heat in under 30 minutes. Those are manufacturer claims, not independent test results.
The product page advertises 4.5–8.1 kW of heat output, or 15,300–27,600 BTU per hour. The current installation manual lists the low setting as 4 kW, or 13,648 BTU per hour, with the same 8.1 kW maximum. Buyers should note that difference in the published specifications.
The standard SaunaTrekker is an insulated pop-up tent advertised for up to four bathers. The XL version is advertised for up to six. Both have weather-resistant exteriors and integrated ventilation.
The installation still needs airflow
The TITAN SL1 installation manual requires continuous ventilation, a noncombustible base and the specified clearances. For sauna-room installations, it calls for at least 54 square inches of free intake area and 39 square inches of free exhaust area. The propane cylinder stays outside the sauna.
Built-in features include an oxygen-depletion shutoff, a tip switch and a 60-minute timer. The approved tent list is limited to SaunaLife’s two SaunaTrekker models. The manual also says local rules may require a licensed or qualified installer for a sauna-room installation.
The practical appeal is a stone-heated sauna where electricity isn’t available. The fuel source and installation requirements differ from the large commercial gas systems in our Bathhouse Philadelphia heater report. For sauna outings at the other end of the scale, Löylyfestivaali’s temporary bathhouse shows how portable facilities can be assembled for a day.
Disclosure: SaunaNews is published by SaunaShare, Inc., which also operates Sauna Marketplace. We sell the SaunaLife TITAN SL1 propane sauna heater through Sauna Marketplace.
